3Com SUPERSTACK 3 4500 Quick Reference Manual - page 17
17
Table 17 RIP View
[4500]rip
Table 18 ACL View
[4500]acl number xxxx
(where xxxx is the acl number)
if-match acl
Configure the IP address range to match the acl
if-match IP
Configure the IP address range to match the IP
if-match IP-prefix
Configure the IP address range to match the IP prefix
if-match tag
Configure the IP address range to match the tag
if-match cost
Configure one of the match rules of route-policy to match
the cost of the routing information
if-match interface
Set to match route whose next hop is designated interface
if-match ip next-hop
Configure one of the match rules of route-policy on the next
hop address of the routing information
Command
Description
Web Command
checkzero
Perform the checkzero operation in the zero field of RIP-1
default cost
default routing cost of an imported route
host-route
Enable receiving host-routes
filter-policy
Spcify a route filtering policy
import-route
Import routes from other protocols into RIP
network
Enable routing protocol on the related network or interface
peer
Specify a peer route
preference
Specify an RIP route preference
reset
Reset RIP configuration
summary
Enable RIP-2 automatic route summarization
timers
Config RIP timers
Command
Description
Web Command
description
Specify the ACL description
rule
Add a subrule to an ACL
Device -> ACL
Security -> Authorized IP
Command
Description
Web Command
Copyright © 2007, 3Com Corporation. All rights reserved.
www.3Com.com
Part Number: 10015872 Rev. AA
Published: January, 2007