3Com SUPERSTACK 3 4500 Quick Reference Manual - page 9
9
ip http
Configure HTTP
Security -> Authorized IP
ip ip-prefix
Configure an address prefix list or one of its items
ip route-static
Configure a static route
Device -> IP Route
lacp system-priority
Configure LACP system priority value
Port -> LACP
link-aggregation group [x]
description
Configure a descriptor for an aggregation group
Port -> Link Aggregation
link-aggregation group [x]
mode
Create a manual or static aggregation group. X=1-32
Port -> Link Aggregation
local-server
Specify local RADIUS server configuration information
local-user
Specify local user configuration and enter local-user view (See
Table 5, “Local-user View,” on page 11
)
Administration ->
System Access
local-user password-display-
mode
Specify password display mode
loopback-detection enable
Enable port loopback detection
loopback-detection interval-
time
Configure the detection interval for the external loopback
condition of each port
mac-address
Configure MAC address
mac-address timer
Configure the aging time of the Layer-2 dynamic address
table entry
mac-authentication
Enable the centralized MAC address authentication feature on
a specified port or globally
mac-authentication authmode
Specify MAC authenticate authmode config
mac-authentication
authpassword
Specify the fixed password
mac-authentication
authusername
Specify the fixed username
mac-authentication domain
Configure the ISP domain used by the centralized MAC
address authentication user
mac-authentication timer
Configure timer parameters of the centralized MAC address
authentication
memory auto-establish
Free memory for routing protocols to run normally
memory limit
Specify the memory limit
memory safety
Display memory safety
ntp-service access
NTP access control
ntp-service authentication
Authenticate NTP timie source
ntp-service authentication-
keyid
Specify NTP authentication keyid
ntp-service max-dynamic-
sessions
Specify the maximum connections
ntp-service reliable
Specify trusted keyid of NTP
ntp-service source-interface
The interface correcponding to the sending NTP packet
ntp-service unicast-peer
Specify the NTP peer
ntp-service unicast-server
Specify the NTP server
password-control
Specify password controls
password-control super
Super user's password controls
poe disconnect*
Set PoE disconnect mode
poe legacy enable*
Enable Legacy detection
poe power-management*
Power Management
poe update*
Update PoE firmware
private-group-id
Tunnel Private Group ID attribute description mode
qos cos-local-precedence-map
Configure “CoS Local-precedence” mapping table
radius nas-ip
Specify the source address of the RADIUS packet sent from
NAS
Command
Description
Web Command