3D Nord magicolor 3100 Maintenance Manual - Error Messages
8
Error Messages
Frequent jams in any area indicate that the area should be checked,
repaired, cleaned, and/or replaced. Repeated jams will also occur if the
media does not match the specifications noted in the
User’s Guide
.
Error Message Problem
Solution
ADC SENSOR
DUSTINESS
WARNING
The density sensor is too
dusty.
Clean the density sensor.
CALL FOR
SERVICE <
X>
A service call is needed
for
> (the specified item). Place a service call. Refer to the Service & Support Guide or www.minolta-qms.com for further information. < COLOR> TONER EMPTY The indicated toner cartridge is empty. Replace the toner cartridge. To order approved consumables, contact your local vendor or www.minolta-qms.com. < COLOR> TONER LOW The indicated toner cartridge is low. There is still enough toner for approximately 100 letter/A4 pages (at 5% coverage) before the printer stops. When the message reads < COLOR> TONER EMPTY, replace the cartridge. < COLOR> TONER MISSING The indicated toner cartridge is missing or misinstalled. Replace the toner cartridge. ENERGY SAVER Energy Saver has been activated. No action needed. FRONT COVER OPEN The front cover is not closed properly. Close the cover. INVALID IMAGING UNIT The printer has detected a nongenuine MINOLTA-QMS imaging unit. To resume printing and to prevent permanent damage to your MINOLTA- QMS printer, replace the imaging unit with a genuine MINOLTA-QMS imaging unit. If you are using a genuine MINOLTA-QMS imaging unit and still receive this error, contact Support. Refer to the Service & Support Guide or www.minolta-qms.com. EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500