Magicolor 3100 maintenance guide ® 1800657-001b ednord - istedgade 37a - 9000 aalborg - telefon 96333500
Dear magicolor 3100 series printer user: thank you for purchasing a magicolor 3100 series printer. Place this maintenance guide near the printer for quick information. For technical support: point your web browser to www.Minolta-qms.Com, and then click on on-line help & drivers. The answer base (the...
1 media specifications all media is fed short edge first and is output to the 250-sheet output tray on top of the printer. The imageable (printable) area for all media sizes is the page size minus 0.157" (4 mm) from all edges. Media inches millimeters source* autoduplex a4 8.2 x 11.7 210.0 x 297.0 u...
2 loading media 1 2 3 a 5 a 5 5 4 ednord - istedgade 37a - 9000 aalborg - telefon 96333500
3 5 76 7 8 8 9 10 11 12 13 ednord - istedgade 37a - 9000 aalborg - telefon 96333500
4 clearing media jams 1 8 9 2 13 5 16 12 6 1 2 3 4 5 4444 5555 a 6 ednord - istedgade 37a - 9000 aalborg - telefon 96333500
5 7 8 9 h b 4444 5555 10 11 12 4444 5555 13 14 ednord - istedgade 37a - 9000 aalborg - telefon 96333500
6 maintenance schedule attention consumable life is expressed in simplex letter/a4 pages at normal 5% coverage in continuous printing. A duplex page is equivalent to two simplex pages. The stated life expectancy of each consumable is based on printing under specific operating conditions, such as rat...
7 consumables life expectancies fuser unit and media feed roller(s) approximately 100,000 simplex pages imaging unit refer to the user’s guide , go to www.Minolta-qms.Com/ support then click on answer base, or go to www.Minolta-qms.Com/products for current life expectancies. Toner percent coverage o...
8 error messages frequent jams in any area indicate that the area should be checked, repaired, cleaned, and/or replaced. Repeated jams will also occur if the media does not match the specifications noted in the user’s guide . Error message problem solution adc sensor dustiness warning the density se...
9 media jam x> duplex jams occur in the duplex area. Locate and remove the jam. Feed jams occur between the media tray and the print engine. A feed jam may be as simple as a sheet of media not being picked up, or it may be that the media was picked up but not fed properly. Fuser jams occur in the fu...
10 replacing a toner cartridge 1 2 3 4 5 6 ednord - istedgade 37a - 9000 aalborg - telefon 96333500
11 7 8 9 ednord - istedgade 37a - 9000 aalborg - telefon 96333500
12 replacing the imaging unit a 1 2 3 4 5 6 ednord - istedgade 37a - 9000 aalborg - telefon 96333500
13 7 8 9 2 1 10 ednord - istedgade 37a - 9000 aalborg - telefon 96333500
14 replacing the fuser unit and media feed roller(s) fuser unit a 1 2 3 b 4444 5555 4 ednord - istedgade 37a - 9000 aalborg - telefon 96333500
15 5 6 7 8 1 1 2 1 2 1 2 1 5555 5555 4444 9 10 11 ednord - istedgade 37a - 9000 aalborg - telefon 96333500
16 media feed roller(s) 1 2 12 6 66 6 13 14 15 16 2 1 3 17 ednord - istedgade 37a - 9000 aalborg - telefon 96333500
17 replacing the transfer unit a 1 2 2 1 1 4444 4444 5555 5555 3 4 5 6 ednord - istedgade 37a - 9000 aalborg - telefon 96333500
18 cleaning schedule cleaning guidelines clean this item thoroughly... After... Exterior once a month or as needed, whichever comes first interior (density sensor) adc sensor dustiness warning appears in the message window. Note: we recommend that you do not clean elsewhere inside the printer. If ne...
19 cleaning the printer exterior cleaning the density sensor a 1 5555 5555 4444 4444 2 3 4 5 2 1 6 ednord - istedgade 37a - 9000 aalborg - telefon 96333500
Ednord - istedgade 37a - 9000 aalborg - telefon 96333500
Ednord - istedgade 37a - 9000 aalborg - telefon 96333500
Ednord - istedgade 37a - 9000 aalborg - telefon 96333500