3D Systems ProJet 1200 User manual - page 17
Other manuals for ProJet 1200:
User Manual
Manual is about: Professional 3D Printer
Original Instructions
of
46
12
3D Systems, Inc.
4 . Remove the peripherals box (A) and the upper foam insert (B).
5 . Carefully remove the printer from the lower boxed foam support and place it on
a solid, level base where it will be used .
CAUTION: Do not install the printer near direct sunlight . If the
material cartridge is exposed to direct sunlight, the resin will begin
to cure .
NOTE: There should be a utility power outlet and an active network
port nearby .
NOTE: There should be a minimum of 6”/152 mm air space between
the back of the printer and any other object .
NOTE: There should be at least 10”/254 mm air space on either side
of the printer .
6 . Remove the protective film (A) covering the display.
A
B
A