3D Systems ProX 500 User Manual - page 16
3D Systems, Inc.
16
Power Switch:
This switch enables and disables power to the MQC System .
LED Display:
The display is operated using the Control Dial (see below) . It gives the user access to all functionality of the
machine .
Emergency Stop Button:
Depress the E-Stop button to cut off all power to the machine . This function is usually reserved for
situations where the machine cannot be stopped normally .
Control Dial:
The user selects functions on the LED Display using this dial control .
A
B
C
D
MQC System User Interface
The User Interface, located on the front panel of the MQC System, consists of a dial-operated menu screen that allows the user to
access the functionality of the system . An E-Stop control is located to the right of the screen and the system power switch is located to
the left . For detailed information on the interface screens, refer to the section,
“MQC System User Interface Settings” on page 48
.
B
C
D
A
MQC SYSTEM COMPONENTS
MQC System Stack Light Conditions
Light Color
Solid
Flashing
Off
Red
E-Stop condition
System fault active
Normal
Yellow
System is in service mode
System warning active and/or
message present on user interface
E-Stop condition or
normal
Green
System is active . Printer
transports are enabled
System is active . Printer transports
are disabled
E-Stop condition or
normal