3D Systems ProX 500 User Manual - page 52

3D Systems, Inc.

52

3 . Quickly press and release knob to display the following screen:

4 . Remove lid from powder container . Place the lid against the RFID pad and hold there until you hear the doors to the fresh powder bin 

    unlock .

5 . Turn on MQC air handler . Open Fresh Bin doors and empty the powder container into Fresh bin, then close doors . You should hear 

    doors relock .

[NOTE: If loading multiple powder containers, you must close and lock the Fresh Bin doors between each container .]

6. When finished with loading powder into the Fresh Bin, return MQC to Full Cycle mode to blend powder or continue in Stop mode if 

    you wish to change Replenish percentage or make any other changes to the setup parameters .

To change Replenish percentage:

1 . Quickly press and release knob to display the following screen:

2 . Rotate control knob to select 

Service/Service/Diag

and quickly press and release knob .

3 . Rotate control knob to select 

Setup

 and quickly press and release knob to display the following screen: