3D Systems ProX 950 User Manual - page 43
3D Systems, Inc.
PRINT PLATFORM INSTALLATION WITHOUT OFFLOAD CART
Verify the MDM is installed in the machine before starting this process. When correctly installed, the print platform sits on the
elevator platform mount. This procedure was done without the MDM installed for clarity only. Always install print pad with
MDM in place. Wear nitrile gloves when handling the print platform to prevent material exposre to your skin.
1. Verify elevator is at its offload position by moving elevator
to the offload position by selecting the
Manual Offload
button on the
Elevator/Leveler
screen under the
Tools
menu.
NOTE: L-Shaped Guides are shown with platform
already on it, for this step the platform is not
normally installed .
2. Place the platform onto the
L-shaped guides
in the rear
of the MDM.
NOTE: This step requires two people to place the
platform on the guides safely, unless using the
help of the offload cart. If using the offload cart,
this can be done by one person .
3. Push the platform against the
front platform guides
.
The left guide has a circular bowl shape for the ball of the
platform to sit on and the right side has a notch.
4. Make sure that the
notches
in the platform engage with
the front platform guides. Once platform is sitting in
notches of guides, move the levers in front of the guides
to the left to lock platform in place.
5. Platform is now installed.
Left
Right
PRINT PLATFORM INSTALLATION WITH OFFLOAD CART
1. The default offload position for the system with a cart should be set higher than one without a cart. Ensure there is enough
room to slide the offload cart under elevator forks without touching the print applicator assembly. To reset the offload
position, see the section,
“Setting the Offload Position.”
2. Lower the print platform onto the elevator forks by pulling lever on the offload cart down.
3. Perform steps 2-4 in above section.
Cart shown outside of printer for clarity.
43