3D Systems ProX DMP 100 User Manual - page 62
58
3D SYSTEMS, INC
.
PN:80-D48 REV A
Powder collecting cans removal
The aim of these following steps is to remove the collecting cans .
1 . Rotate the airlock in OPEN position .
2 . Open the front doors .
3 . Open the airlock door .
4 . Install the screw caps on the airlock .
5 . Close the airlock door .
6 . Rotate the airlock in CLOSE position .
7 . Open the glove doors .
8 . Remove the funnel (1) from the collecting cans location .
9 . Remove the collecting cans from their location (2) .
10 . Close the collecting cans with their cans (3) .
11 . Put the collecting cans on the airlock .
12 . Close the glove doors .
13 . Rotate the airlock in OPEN position .
14 . Open the airlock door .
15 . Remove the collecting cans from the airlock .
16 . Close the airlock door .
17 . Close the front doors .
18 . Use a sieving system to sift the usable powder for the next job .
1
Funnel
2
Collecting cans
3
Screw caps