3D Systems ProX DMP 100 User Manual - page 79

75

3D SYSTEMS, INC

.

PN:80-D48 REV A

EVERY 6 MONTHS MAINTENANCE

Gas filter replacement

The gas filter must be replaced every 6 months. The gas filter is located under the front doors.

Part required :

• 

Filter element : 1001884R00 .

1 .  Make sure the gas and purge are not activated .

2 .  Open the access door located below the front doors of the machine (1) .

3 . 

Remove the filter guard from the filter cap by unscrewing it (2).

4 . 

Remove the filter element. Dispose of it in accordance with all local/regional/national, state and federal regulations.

WARNING : FLAMMABLE POWDERS .

PLACE THE USED FILTER ELEMENT IN A CLOSED METALLIC CONTAINER IN A ROOM WITH FIRE DETECTION .

5 . 

Clean the filter guard with the use of a damp cotton cloth.

6 . 

Install the new filter element.

7 . 

Install the filter guard.

8 .  Close the access door located below the main cabinet .

1

Filter cap

Filter guard

2