3D Systems ProX DMP 100 User Manual - page 77
Other manuals for ProX DMP 100:
Original Instructions Manual
Manual is about: 3D Production Printer
of
83
73
3D SYSTEMS, INC
.
PN:80-D48 REV A
13 . Clean the cover panel (inside and outside) with the use of damp cotton cloth to neutralize any presence of the
condensate (black particle aspect) .
14 . Clean the sides of the enclosure and protection bellow with the use of a damp cotton cloth to neutralize any presence
of the condensate (black particle aspect) .
15 .
Remove any presence of powder on the enclosure and protection bellow with the use of a natural fiber brush and a
vacuum cleaner .
Caution: make sure not to damage the protection bellow during cleaning .
16 . Put back the cover panel and secure it by tightening the screws .
17 . Close the rear doors of the printer .
Metal particle
condensate
- Highly
combustible