1. DL manuals
  2. 3i Corporation
  3. Wireless Router
  4. Pegasus NX
  5. Installation Manual

3i Corporation Pegasus NX Installation Manual

Other manuals for Pegasus NX: User Manual, User Manual

Summary of Pegasus NX

  • Page 1

    All trademarks belong to 3i-corporation or its affiliated and subsidiary companies, all rights reserved. Installation manual ©2013 3i-corporation. All rights reserved. ™ nx.

  • Page 3

    Iii table of contents introduction ................................................................................................................ 1 scope ...................................................................................................................................................

  • Page 4

    Iv how to wire sensors/detectors to pegasus™ nx? .................................................. 29 single-mode: normally close (n.C.) contacts without end of line (eol) resistor ........................................ 33 single-mode: normally close (n.C.) contacts with end of line (eol) resisto...

  • Page 5

    1 introduction scope this installation manual is aimed in providing detailed information and complete listing as a reference to install pegasus™ nx. Audience this installation manual is intended for end users who are going to install pegasus nx. The readers or end-users of this installation manual s...

  • Page 6

    2 text conventions begin instruction: to begin a procedure under any topic. Use a numbered list for points under procedure. Note: provides a message or reminder related to a topic or section. Warning: information provided under this section must be followed. Several different sources of power can be...

  • Page 7

    3 overview about the installation manual this installation manual is to describe the pegasus™ nx features, technical specifications, and installation instructions including components description, mounting, and wiring. What is pegasus™ nx? The pegasus™ nx alarm panel communicator is an extremely com...

  • Page 8

    4 telephone line at client etc. Any monitoring software that communicates with receivers: ademco-685, sur-gard, or cm plus can be used. Transmission of real time alarm panel events via wi-fi network is possible, if other interfaces are failed or when the preferred interface is wi-fi. Alteration of t...

  • Page 9

    5 technical specifications power supply 1 input voltage range 9vdc – 15vdc 2 maximum current 450ma battery 1 battery type lithium-polymer capacity: 2000mah 2 battery backup upto 6 hours depending on network conditions processor 1 cpu arm 32bit cortex-m3 2 speed 32mhz ethernet 1 network standard ieee...

  • Page 10

    6 gsm/gprs 1 modem quad-band egsm 850 / 900 / 1800 / 1900 mhz 5 sim card holder dual sim support 2 protocol support tcp/ip or udp/ip 6 antenna: impedance 50 Ω 3 antenna type external dipole antenna module (dam) 7 antenna: peak gain 2.0 dbi 4 antenna: frequency range 824-960mhz，1710- 2170mhz 8 antenn...

  • Page 11

    7 virtual telephone line output 1 constant current source for alarm panel 25ma, 20v telephone line connection 1 maximum telephone line voltage detection 100vac, 48vdc 2 minimum telephone line voltage detection 3vdc pgms 1 3 pgms- open collector type supporting 300ma sink current per pgm 2 1 pgm- spd...

  • Page 12

    8 usb 1 usb 2.0 device interface mini b usb 3 usb full speed 12 mbit/s 2 use for configuration, firmware upgradation and to view debug messages tamper switch 1 tamper type internal 2 use to trigger an event on unauthorized enclosure opening leds 1 power on status first led from top to indicate the p...

  • Page 13

    9 board dimensions 1 length 82mm 3 thickness 1.6mm 2 width 80mm 4 number of layers of pcb four enclosure dimensions 1 length 112mm 3 height 4.2mm 2 width 112mm.

  • Page 14

    10 pegasus™ nx features built-in telephone line cut off detector that enables the device to detect telephone line cut off and send occurrences to the zeus™ server. Built-in alarm panel cut off detector that enables the device to detect alarm panel cut off and send occurrences to the zeus™ server. Pe...

  • Page 15

    11 built-in dual sim card holder. The dual sim card holder allows you to insert two sim cards. You can use two sim cards from the same or different service providers (s). Uses cryptographic data transmission by aes (rijndael) 128/256 bits encryption, and thus secures your data from spying. Can be us...

  • Page 16

    12 offers possibility to communicate with both the primary and secondary zeus™ servers using different interfaces. This feature makes the device more robust and dependable as an alarm panel communicator. You can configure different interfaces as per your preference for both the primary and secondary...

  • Page 17

    13 pegasus nx components description pegasus™ nx components components apart from pegasus™ nx battery & pegasus™ nx circuit board that together form the pegasus™ nx alarm panel communicator is listed in the below table: pegasus™ nx front cover the pegasus™ nx front cover is the outermost panel that ...

  • Page 18

    14 pegasus™ nx front panel the pegasus™ nx front panel is placed between the front cover and the rear panel. It fits perfectly on the pegasus™ nx rear panel and secures the pegasus™ nx circuit board, terminals, battery, etc from damage. Pegasus™ nx rear panel the pegasus™ nx rear panel fits properly...

  • Page 19

    15 pegasus™ nx wall mounting bracket the wall mounting bracket secures pegasus™ nx on wall. Pegasus™ nx led pipe led pipe helps to transmit light emitted by the on- board leds to the front panel and the front cover. Pegasus™ nx wi-fi antenna rp-sma wi-fi antenna is connected to the rp-sma wi-fi adap...

  • Page 20

    16 how to mount pegasus nx? Mounting instructions warning: to mount pegasus™ nx and make sure it stays on the wall, use a proper mounting kit for the job. Just remember, the anchors need to hold five times the weight of what you're putting on the mount. Requirements materials wall bracket nylon anch...

  • Page 21

    17 mounting bracket on a masonary wall search an appropriate and secure place to fix the wall mounting bracket and install pegasus nx. To mount bracket on a masonary wall 1. Position the wall bracket on the wall and mark out the mounting holes, see image a. 2. Next drill the mounting holes with a ma...

  • Page 22

    18 4. A fully secured wall bracket looks straight, see image c. Mounting bracket on a timber stud wall the only difference when mounting the bracket to a plaster wall is that you must position the wall bracket so that it is attached to the middle of a timber stud. The plaster itself might not handle...

  • Page 23

    19 fixing pegasus™ nx on the wall bracket once the wall bracket is properly fixed on the wall, straight fix pegasus™ nx to the wall bracket and follow the instructions provided. To fix pegasus™ nx on the wall bracket 1. Place the back side of pegasus nx on the wall mount bracket as per the numbering...

  • Page 24

    20 3. A properly fixed pegasus™ nx looks straight and stable on the wall, see image c. In case it is in the tilted condition, simply adjust the wall bracked by slightly loosing the four screws as the wall bracket is built-in adjustable screw holes..

  • Page 25

    21 how to connect wi- fi antenna to pegasus™ nx? Requirements materials rp-sma wi-fi antenna ** u.Fl/ipx to rp-sma pigtail wi-fi rf cable adapter** **available in the box, comes with the pegasus nx package 7.

  • Page 26

    22 to connect wi-f i antenna to pegasus™ nx 1. Open the pegasus™ nx front panel. 2. On the pcb, connect the u.Fl adapter to the u.Fl/ipx connector as shown in image b. 3. Connect the rp-sma wi-fi antenna to the rp-sma connector (part of the pigtail cable). Note: figure b is for demonstration purpose...

  • Page 27

    23 how to connect gsm antenna to pegasus™ nx? Requirements materials sma gsm antenna** **available in the box, comes with the pegasus™ nx package 8.

  • Page 28

    24 to connect gsm antenna to pegasus™ nx 1. Connect the rp-sma connector (gsm antenna) on the pcb mounted, right-angled rp_sma rf jack as shown in the below image. Note: figure a is for demonstration purpose only. Here, the pegasus™ nx rear panel is not visible but in actual condition only the threa...

  • Page 29

    25 how to insert gsm sim cards? Requirements materials gsm sim card(s)** **not provided in the box. Sim cards are not the part of pegasus nx package. Pegasus™ nx is built-in a sim card holder that can accommodate two sim cards. Once secured properly, these sim cards offers wireless communication cap...

  • Page 30

    26 to install the sim cards 1. Open the sim cover by sliding it in the horizontally outer direction, and then lifting it in the upward direction. 2. The sim card holder can accommodate two sim cards. Sim card 1 should be placed in the lower slot (towards the gsm antenna). Sim card 2 should be placed...

  • Page 31

    27 how to connect pegasus™ nx? Wiring instructions warning: wiring should be done by the trained 3i-corporation authorized service personnel only. Never install the device during lightning or storm. Always use genuine 3i-corporation approved accessories with the device. Turn off power supply during ...

  • Page 32

    28.

  • Page 33

    29 how to wire sensors/detectors to pegasus™ nx? Pegasus™ nx is built-in two zones which are extended to four zone inputs. Pegasus™ nx supports zone input wiring in both single-mode and double-mode. A sensor or detector can be connected in nine different ways. The below table shows the different typ...

  • Page 34

    30 single-mode: normally open (n.O.) contacts with end of line (eol) resistor to view the full sensor or detector wiring, click here single-mode: normally close (n.C.) contacts without end of line (eol) resistor, with tamper recognition to view the full sensor or detector wiring, click here single-m...

  • Page 35

    31 double-mode: normally close (n.C.) contacts without end of line (eol) resistor, with tamper recognition to view the full sensor or detector wiring, click here double-mode: normally close (n.C.) contacts with end of line (eol) resistor, with tamper & wire fault recognition to view the full sensor ...

  • Page 36

    32.

  • Page 37

    33 single-mode: normally close (n.C.) contacts without end of line (eol) resistor.

  • Page 38

    34 single-mode: normally close (n.C.) contacts with end of line (eol) resistor.

  • Page 39

    35 single-mode: normally open (n.O.) contacts with end of line (eol) resistor.

  • Page 40

    36 single-mode: normally close (n.C.) contacts without end of line eolresistor, with tamper recognition.

  • Page 41

    37 single-mode: normally close (n.C.) contact with end of line (eol) resistor, with tamper & wire fault recognition.

  • Page 42

    38 double-mode: normally close (n.C.) contacts without end of line (eol) resistor.

  • Page 43

    39 double-mode: normally close (n.C.) contacts without end of line (eol) resistor, with tamper recognition.

  • Page 44

    40 double-mode: normally close (n.C.) contacts with end of line (eol) resistor, with tamper & wire fault recognition.

  • Page 45

    41 double-mode: parallel connection.

  • Page 46

    42 how does leds work? Leds description pegasus™ nx is built-in seven on board leds that emits light to the pegasus™ front cover and front panel via specially designed and secured led pipes under specific conditions. 12.

  • Page 47

    43 leds condition function power on status led is off (a) application is not running, module is not in the working state. Led is on (a) application is running, module is in the working state. Telephone line cut off led is off (a) telephone line is not connected to the module. Led is on (a) telephone...

  • Page 48

    44 leds condition function alarm led is off (a) alarm panel is not connected to the virtual line. Led is on (a) alarm panel is connected to the virtual line wi-fi status led is off (a) wi-fi is not activated. (b) module is not connected to internet via wi-fi. Led is on (a) wi-fi is activated. (b) mo...

  • Page 49

    45 appendix abbreviation 1 gps global positioning system 6 n.O. Normally open 2 gsm global system for mobile communications 7 n.C. Normally close 3 gprs general packet radio service 8 com common 4 sim subscriber identity module 9 gnd ground 5 wi-fi wireless fidelity 10 eol end of line 13.