3M 1200 User Manual - Operation
1200/2200 Sound Level Meter Operator’s Manual
11
4. OPERATION
Before taking measurements, there is a series of quick checks that should
be performed. After switching the unit ON check for a LOBAT indication
on the display, and replace the battery if needed (see Section 3.1).
Although the model 1200 will maintain accurate calibration over a long
period of time, the calibration should be checked before each use.
The calibration should also be checked and verified after each use.
Set the RESPONSE, WEIGHTING, and RANGE (dB) switches as needed.
Hold, set, or tripod mount the meter in the desired location. If a MAX,
MIN, or LEQ measurement is needed, be sure to reset the meter before
taking the measurements. It is good practice to document all measurement
conditions and meter settings for possible future reference.
4.1 Meter/Microphone Placement:
Whenever possible, the meter should be tripod-mounted in a relatively
open area to minimize reflections from the body or other large reflective
structures. Avoid placement against a wall or in a corner. A threaded
bushing on the back will accept a standard 1/4-20 tripod fitting.
The microphone cartridge used on the models 1200 and 2200 is a free-
field microphone. Point it directly at the noise source (0 degrees ).
Random incidence measurements may be taken with the 1200 if the plastic
random incidence corrector supplied with the BK4936 microphone is used.
The random incidence corrector is a black plastic lipped sleeve packed in
the BK4936 packing container. To attach the corrector, position the end of
the sleeve without the lip over the grid of the mircophone and gently press
down until a snap fit is achieved.
4.2 Background Noise:
Background noise can cause considerable error in measurement when its
level is close to that of the particular sound source of interest. When it is
not possible to eliminate or reduce the background noise, use the curve
shown in Figure 3 to correct for the effect of the background noise on the
measurement.
Operation
1200/2200 Sound Level Meter Operator’s Manual
12
Operation
For example, if the background noise is 45dB and the sound of interest
measures 51dB, the difference between measurement and background
noise is 6dB. From Figure 3, for a 6dB difference, 1.3dB should be
subtracted from the measurement. The correct measurement is therefore
51dB - 1.3dB = 49.7dB.
Figure 3. Effects of Backgound Noise
4.3 Wind Screen Effects:
To prevent measurement errors caused by wind blowing across the micro
phone, the use of a windscreen is recommended. The wind screen will
reduce wind effects and will also help protect the microphone under dusty,
oily, or humid conditions. Acoustic attenuation effects of the windscreen
(WS-7) are shown in Figure 4.
Figure 4. Effects of Windscreen