3M ChassisTouch 15 User's Installation Manual - Testing The Chassistouch Fpd
Chapter 2 Setting Up Your ChassisTouch FPD Monitor
3M Touch Systems Proprietary Information
19
Testing the ChassisTouch FPD
Note:
The ChassisTouch FPD does not have a power status light.
After connection, the monitor will switch on automatically. Before you
test your touch monitor, make sure all cables are connected properly.
Be sure to tighten all cable screws.
To test that the monitor is working properly:
1.
Turn on your computer.
2.
Make sure the video image is displayed. If it is not, turn on your monitor.
3.
Make sure the video image is centered within the screen area. Use the
monitor controls to adjust the image, if necessary.
You can adjust the horizontal and vertical position, image size, contrast,
and brightness to better suit your video card and your personal
preference. Refer to Chapter 3 for more information on using the
on-screen menu to adjust the video display.
Installing TouchWare Software
TouchWare software includes the touch screen driver and control panel
that enables your touch screen to work with your computer. When you
install the CD, TouchWare will automatically load the correct driver for
your system. 3M Touch Systems currently supports touch screen drivers
for the following PC operating systems:
•
Windows 2000
•
Windows NT 4.0
•
Windows 9x
•
Windows Me
These drivers, as well as relevant documentation, can be found on the
latest 3M Touch Systems CD. After the software is installed, restart
your computer to load and activate the touch screen driver. To complete
the setup of your touch monitor, make sure you calibrate the touch
screen.
Calibrating the Touch Screen
After you connect your touch monitor and install TouchWare, you must
calibrate the touch screen.
Calibration
serves two purposes:
•
Sets the active area of the touch screen
•
Aligns the touch screen’s active area to the underlying video