3M DE343 Product Safety Manual - Installation
5
3M™ Digital Easel
© 3M 2005. All Rights Reserved.
Installation
Installation
Note: Photos and/or illustrations may not match exactly the hardware provided.
Installing the Wall Bracket
Unpacking Wall Bracket and Hardware
1. Stand the shipping container on its bottom side on the floor.
2. Open the top side of the shipping container.
3. Remove the 3M Digital Easel and accessories from the shipping container.
WARNING
To reduce the risk associated with muscle strain:
• Always use more than one person when installing or removing the 3M Digital Easel
4. Locate and remove the wall bracket and hardware.
Installation for a Hollow Wall-Drywall
WARNING
• Install the 3M Digital Easel on a wall with 1/2-inch-thick drywall minimum.
• Use only 3M recommended wall mounting hardware.
• Follow all installation instructions carefully.
• Make sure mounting screws are properly sized to handle the weight of the 3M Digital Easel.
• Make sure mounting hardware is securely anchored to a solid structure.
• Proper installation must be performed by qualified service technicians, as outlined in the installation
instructions. Failure to do so could result in serious injury and/or damage to the 3M Digital Easel.
1. Determine the desired location of the unit.
2. While holding the bracket in place, use a
carpenter’s level to ensure the proper level and then
mark a minimum of two hole locations on the wall.
Ensure that no studs are behind the hole locations.
Note: Drawings may not depict actual hardware used.
3. Using a Phillips screw driver, screw the supplied
anchors into the wall until they are flush with the
wall surface using one for each identified hole
location.