3M Jooltool Owner's Manual - Operation
OPERATION
THESE ARE GENERAL RULES OF OPERATION INTENDED AS GUIDELINES ONLY.
FOR MORE INFORMATION, CONSULT THE PROVIDED INSTRUCTIONAL DVD.
USING THE NINJA SEE-THRU™ FELT WHEEL
IMPORTANT!
MOUNT YOUR FELT DISC ONTO A BACKPAD BEFORE USE!
ONLY when using the FELT DISC for the VERY FIRST time, you should charge the
wheel HEAVILY with POLISHING COMPOUND to a high saturation.
Always apply compound from UNDERNEATH of wheel.
Never attempt to use FELT DISC WITHOUT compound.
To charge the felt disc for the first time, follow these steps.
NOW YOU ARE READY TO POLISH WITH YOUR FELT DISC!
Use the FELT DISC just like other abrasives; PLEASE OBEY ALL SAFETY RULES!
DO NOT FORCE TIP OF SHARP TOOLS DIRECTLY INTO FELT DISC!
You will create a deep groove in the disc, having to redress the wheel
to regain a flat surface. If this happens, see below.
If the disc has developed GROOVES, you can remove
them by applying a SANDING BLOCK to the BOTTOM
of the SPINNING disc. Make full contact with the wheel,
hold the block stationary under the spinning disc and
apply firm pressure until the wheel is SMOOTH and EVEN.
STORE IN A DRY PLACE & KEEP AWAY FROM WATER! DO NOT USE IF WET!
Felt disc can distort and swell if exposed to water.
STEP 1:
Apply compound
from UNDERNEATH
of the spinning
FELT DISC.
STEP 2:
Dress with a solid,
smooth & flat piece
of metal or wood.
!
13