3M MicroTouch CT150 Install Manual - page 3
3M Touch Systems Technical Note
Product:
MicroTouch
™
CT150 Monitor Industrial Bezel – Installation Instructions
Document #33148 3M Touch Systems Inc. Proprietary Information © 2006 3M. All Rights Reserved.
Page 3
4.
Inspect the bezel assembly. Confirm the presence and integrity of both gaskets. Confirm the
presence and integrity of 8 threaded studs on the outside diameter of the bezel. Confirm the
presence and integrity of 10ea.- I.D. threaded extensions on the inside diameter of the bezel. See
Figure 2.
Figure 2 – Part identification
5.
The bezel is designed such that the frame piece immediately outside of the I.D threaded
extensions
pilots on the outside
of the monitor frame. Place the bezel “face down” on the
protected work surface with the studs and threaded extensions facing you. Loose-fit the bezel
onto the CT150 monitor by carefully lowering the chassis monitor into the bezel frame.
Be
careful not to drop the monitor onto the bezel as damage to the monitor may result.
Note
: There is no top or bottom to the bezel - either orientation is correct.