3M MicroTouch Display C1700SS Installation Manual - Adjusting The Video Display
3M™ MicroTouch™ Display C1700SS Installation Guide
17
3M Touch Systems Proprietary Information
CHAPTER 4
Adjusting the Video Display
Your C1700SS Display has several control buttons and an on-screen menu for adjusting
the video display. For example:
• You can adjust the pixel clock and phase to eliminate noise.
• You can adjust the image contrast and brightness to your lighting conditions.
• You can adjust the horizontal and vertical position of the image.
This chapter presents guidelines for adjusting the video display and describes how to use
the available display controls to adjust the image to your liking. Before you make any
adjustments:
• Be sure to set the controls under your normal lighting conditions.
• Display a test image or pattern whenever you adjust the video.
Controls for Adjusting the Video Display
Your C1700SS Display has five controls for adjusting the video display.
MENU EXIT UP DOWN LED
POWER AUTO
• MENU – The first press of the menu button will call up the On Screen Display (OSD).
A second press will enter the current sub-menu of the OSD. Further presses will allow
you to cycle through the available sub-menu options.
• EXIT -- Return to the previous OSD menu level. If you are at the top level this will
close the OSD display.
• UP -- Increases the value of the selected menu option.
• DOWN -- Decreases the value of the selected menu option.
• LED – Indicates whether the display is on.
• POWER – Turns the display on or off.
• AUTO -- Auto-adjust to bring video settings to their optimal level.
If you do not press any buttons for approximately 20 seconds, the OSD times out and
hides the menu options. You can press the Menu button at any time to display the OSD
again.