4xem IPCAMWL40 User Manual - Installation

- 6 - 

Installation 

Hardware installation 

Please verify that your product package contains all the 

accessories listed in the foregoing Package Contents.  

Depending on the user’s application, an Ethernet cable 

may be needed. The Ethernet cable should meet the specs 

of UTP Category 5 and not exceed 100 meters in length. 

Upon powering up, the device runs through a self-test procedure and the front LEDs 

will blink between green and red a few times.    If self-test passes, the LED will be green 

and the Network Camera will standby for getting IP address. If self-test fails the red 

LED will blink several times. Refer to Appendix A for troubleshooting. 

The Network Camera will first detect Ethernet. If it does not connect to Ethernet, the 

Network Camera will try WLAN. During the searching and connecting process to the 

wireless access point or station, the red LED of the Network Camera will flash every 

second.    Until the Network Camera connects to the other wireless device, the red LED 

will become lighted.    Operating in either network mode, the green LED will flash every 

second as heartbeat to indicate alive. 

To install in Ethernet 

Make sure the Ethernet is firmly connected to a switch hub. After attaching the 

Ethernet cable plug in the power adapter. If the LED turns out to be steady green after 

 Connect the power adapter jack to the Network 

Camera before plugging in to the power socket. This will 

reduce the risk of accidental electric shock.