4xem sku IPCAMW40 User Manual - Appendix

- 47 - 

Appendix 

A. Troubleshooting 

Status LED 

After powering up, the Network Camera performs a self-diagnostic to detect any 

hardware defects. The following table lists the LED patterns in general . In case of any 

fatal error, the LED will blink in a pattern other than those below.   

Condition LED 

color 

During self-diagnostic after power on 

Blink in interchanged green and red 

Ethernet signal is lost 

Steady red till Ethernet is detected 

Before network is setup 

Steady green till IP address is confirmed 

After network is setup 

Blink green every second 

Any hardware failure 

Other patterns 

Reset and restore 

There is a button hidden in the pinhole beside the 

Ethernet socket. It is used to reset the system or 

restore the factory default settings. Sometimes 

resetting the system can make the system back to 

normal state. If the system still has problems after 

reset, restore the factory settings and install again. 

RESET:    

Poke the wrench to click on the button. 

RESTORE:   1. Poke the wrench to press on the 

button continuously. 

2. Wait for self-diagnostic to run twice. 

3. Withdraw the wrench as soon as the second 

self-diagnostic starts.

 Restore the factory defaults 

will erase any previous settings. 

Reset or restore the system after 

power on.