4xem sku IPCAMW40 User Manual - Installation

- 6 - 

Installation 

Hardware installation 

Please verify that your product package contains all the 

accessories listed in the foregoing Package Contents.  

Depending on the user’s application, an Ethernet cable 

may be needed. The Ethernet cable should meet the specs 

of UTP Category 5 and not exceed 100 meters in length. 

Upon powering up, the device runs through a self-test procedure and the front LEDs 

will blink between green and red a few times.    If self-test passes, the LED will be green 

and the Network Camera will standby for getting IP address. After getting IP Address, 

the LED will blink green every second. If self-test fails the red LED will blink several 

times. Refer to Appendix A for troubleshooting. 

The Network Camera provides a general I/O terminal block with one digital input and 

one relay switch for device control. Pin 1 and pin 2 can be connected to an external 

sensor device and the state of voltage will be monitored from the initial state 'LOW'. 

The relay switch of pin 3 and pin 4 can be used to turn on or off the external device. 

1      DI- 

INPUT (Initial state of DI is low) 

2   DI+ 

INPUT (Max. 50mA, 12VDC) 

3      SW_COMMON  

OUTPUT (open from SW_OPEN at initial state) 

(close with SW_OPEN when set DO to ON) 

4   SW_NOPEN     

OUTPUT (Max. 1A, 24VDC or 0.5A, 125VAC

 Connect the power adapter jack to the Network 

Camera before plugging in to the power socket. This will 

reduce the risk of accidental electric shock. 

  Consult with the dealer of the peripherals for correct installation.