4xem WL80 User Manual - page 12

- 8 - 

For the series number in the “Serial Number” field, please check the label on the 

bottom of the camera. 

The IP addresses shown in the "Current IP Address" field reflect those on the local 

network.  They may be from the DHCP server.  If there is no DHCP server, the 

camera will try to find a free IP address (this takes from 15 second to 3 minutes, 

depending on the LAN status). The method of finding IP address is seeking from 

192.168.0.99, to 192.168.0.254. If any of the address inside this range is free, the 

Network Camera will be assigned to this IP address, and its subnet mask would be 

255.255.255.0. If none of the addresses is free, the Network Camera will try the 

range from 192.168.0.2 to 192.168.0.98.  After an IP address is assigned to the 

camera, the “Activity” status LED blinks. 

The new UPnP function will always assign an IP address for the Network Camera.  

The Administrator can click on button “Link to selected device” to    connect the I.E. to 

the camera. 

If the camera is not on the IP installer list, click on the “Search” button to search for 

the camera on the LAN.