4xem WL80 User Manual - Application Setup

- 48 - 

Application Setup 

Weekly Schedule 

“Sun” ~ “Sat” Select the days of the week to perform the following operations. 

“Snapshots begin at” Set the time to start operations.   

“Snapshots stop at” Set the time to stop operations. Setting identical begin time 

and stop time means 24-hour operation. 

“All the time except for the above schedule” Invert the selected schedule. The 

default setting of this option is checked. 

“Snapshot file name prefix” Specify the prefix name for the snapshot file. Please 

check naming rule of snapshot file for more detail. 

Event Operation 

“Delay second(s) before detecting next event” Set the time delay before 

restarting to check on the triggering condition when the current condition is 

triggered. 

“Send pre-event image(s) when event occurs” Specify how many pre-event 

snapshot will be sent if events happen. 

“Trigger condition” There are four conditions relative to the digital input and three 

windows for motion detection. More than one condition can be selected at once. 

Select the appropriate digital input condition that suits the characteristics of the 

external device. “high”, “low” selects level-triggering via external voltage input. 

“rising”, “falling” is for edge-triggering. There are three windows for motion detection 

each can be assigned a name. If motion detection has not been set up, it will not be 

shown. If this happens, clicking on “Motion detection” and a note will show to direct 

the User to the configuration page for motion detection. 

“Trigger action” There are four options for two types of action. More than one 

condition can be selected at once. While choosing to trigger an output alarm, the 

digital output will short both pins and complete the external device’s circuit. The 

normal state is open. Either email or FTP can be used to command uploading