909 909210TS Instruction Manual - Unpacking
10
Unpacking
Due to modern mass production techniques, it is unlikely
that your 909 Power Tool is faulty or that a part is missing.
If you find anything wrong, do not operate the tool until the
parts have been replaced or the fault has been rectified.
Failure to do so could result in serious personal injury.
1. Remove all loose parts from the carton.
2. Remove the packing materials from around the saw.
3. Carefully lift the saw from the carton and place it on a
level work surface.
Before using the machine
WARNING.
Before connecting a tool to a power source
(power point receptacle, outlet, etc.) be sure that the voltage
supply is the same as that specified on the nameplate of
the tool. A power source with a voltage greater than that
specified for the tool can result in serious injury to the user,
as well as damage to the tool. If in doubt, do not plug in
the tool. Using a power source with a voltage less than the
nameplate rating is harmful to the motor.
The machine has to be adjusted so that the height of the
uppermost tip of the blade is just higher than the work piece.
All the guards and safety devices have to be properly fitted
before the machine is switched on.
It must be possible for the saw blade to run freely.
When working with wood that has been processed before,
watch out for foreign bodies such as nails or screws etc.
Remove any such foreign bodies.
Before you actuate the On/Off switch, make sure that the
saw blade is correctly fitted and that the machine’s moving
parts run smoothly.
WARNING.
If you have any doubts, get an expert from an
authorised service centre to help you set up the table saw.
It is too dangerous to guess the procedure.
Assembling the side support extension table
CAUTION.
Always pull out the mains power plug before
carrying out any maintenance, conversion or assembly work
on the table saw.
Fitting the side support extension table:
1. Push the round rods through the side holes of the table.
2. Make sure the rods go right through the legs.
3. Push the extension table
lugs (23) into the end of
the rods then screw these
into place.
4. Slide the side table to the
desired distance.
5. Pull down the legs. Make
sure the table saw is on a
level surface and is stable.
6. Once the side table is at the
desired distance, use the lock knobs to lock in place.