909 909210TS Instruction Manual - Accessories
8
WARNING!
For your own safety read instruction manual
before operating mitre saw. Wear eye protection. Keep
hands out of path of saw blade. Do not operate saw without
guards in place. Do not perform any operation freehand.
Never reach around saw blade. Turn off tool and wait for
saw blade to stop before moving workpiece or changing
settings. When changing the blade, replace and secure all
guarding to its original position and correctly before starting
tool. Disconnect power (or unplug tool as applicable) before
changing blade or servicing. Do not expose to rain or use in
damp locations. To reduce the risk of injury, return carriage
to the full rear position after each crosscut operation.
The tool must be used only for its prescribed purpose.
Any use other than those mentioned in this Manual will
be considered a case of misuse. The user and not the
manufacturer shall be liable for any damage or injury
resulting from such cases of misuse.
The manufacturer shall not be liable for any changes made
to the tool nor for any damage resulting from such changes.
Even when the tool is used as prescribed it is not possible
to eliminate all residual risk factors. The following hazards
may arise in connection with the tool’s construction
and design:
•
Damage to the lungs if an effective dust mask is not worn.
•
Damage to hearing if effective earmuffs are not worn.
Accessories
The 909210TS Table Saw is supplied with the following
accessories as standard:
•
24T Blade (fitted)
•
Rip Fence
•
Mitre Guide
•
Blade Guard
•
Push Stick
•
Saw blade key
•
Flange Key
The table saw is designed for the cutting of timber and
plastic commensurate with the machine’s size. The machine
is not to be used for cutting firewood. The machine is to be
used only for its prescribed purpose. Any use other than
that mentioned will be considered a case of misuse. The
user/operator and not the manufacturer shall be liable for
any damage or injury resulting from such cases of misuse.
The machine is to be operated only with suitable saw
blades, which includes all TCT blades. It is prohibited to use
any High-Speed Steel blades in this machine.