A&D HW-100KGL Instruction Manual - 14.2.4 Span Calibration

HW-G Instruction Manual Page 42

HW-G OZIM v1a

14.2.3 Calibration of the Zero Point

Step 8 Press and hold the 

 CAL 

 switch to

enter the calibration mode after

displaying normal

weighing for 30 minutes.

Then the 

 Cal 0 

 is displayed.

Step 9 With nothing on the pan, press the

ENTER 

 switch while the stable

mark is displayed. The scale

stores the current condition as the

zero point. .

Step 10

The scale displays 

 5pn1 

 for

several seconds. If finishing

the calibration mode at this

stage (Zero calibration only),

press CAL to proceed to step 13.

14.2.4 Span Calibration

Step 11 Set the value of the calibration

mass using the following switches.

(The initial value depends upon the

particular model.)

^

 switch

Selecting the value of

a digit.

<

 switch

Selecting a digit.

Step 12 Place the mass’ selected at

step 11’ onto the pan. When the

stable mark is displayed press

the 

 ENTER 

 switch.

The scale then calculates the

span and stores the value.

Step 13 The scale displays 

 end 

 at the

finish.

Remove the mass from the pan.

Step 14

Press the  

CAL

  switch to return

to the normal weighing mode.