A&D UA-767NFC Instruction Manual - Measurements
English
12
START
At heart level
Measurement
in progress
Systolic pressure
Diastolic pressure
Pulse
rate
Exhausts remaining
air automatically
Press
Pressurizing
Zero display
Starts inflation
All of the display
segments displayed
Measurements
Before measurement, read “Notes for Proper Measurement” on page 14.
Normal Measurement
1. Place the cuff on the arm (preferably the left arm).
Sit quietly during measurement.
2. Press the
START
button.
All of the display segments are displayed.
Zero (0) is displayed blinking briefly.
The display changes, as indicated in the figure
at the right, as the measurement begins. The
cuff starts to inflate. It is normal for the cuff to
feel very tight. A pressure bar indicator is
displayed, on the left edge of the display,
during the inflation.
Note: If you wish to stop inflation at any time,
press the
START
button again.
3. When inflation is complete, deflation starts
automatically and
(heart mark) blinks,
indicating that the measurement is in progress.
Once the pulse is detected, the mark blinks
with each pulse beat.
Note: If an appropriate pressure is not
obtained, the device starts to inflate
again automatically.
To avoid re-inflation, see “Measurement
with the Desired Systolic Pressure”
on the next page.
4.
When the measurement is complete, the
systolic and diastolic pressure readings and
pulse rate are displayed.
The cuff exhausts the remaining air and deflates
completely.
5. Press the
START
button to turn the device off.
After one minute of non-operation, the device
will turn off automatically.
Note: Allow at least three minutes between
measurements on the same person.