A.J.Antunes HCT-5H User Manual - Hct-5H Bun Toaster
HCT-5H BUN TOASTER
10
A.J. Antunes & Co.
P/N 1011256 Rev. B 03/15
McDonald’s
REMOVING BELTS
1. Turn the toaster off. The toaster enters a cool-
down mode and automatically shuts down when
complete.
2. Unplug the power cord once the cool-down period
is complete.
3. Put on neoprene gloves. Remove the Bun Feeder,
Crumb Tray, and Bun Buffer Frame.
4. Set the Compression Knob to 7.
5. Unlock the latch on the non-control side of the
toaster. Open the side panel.
6. Refer to Figure 5. Lift the latch just above the Bun
Compression Knob and then open the Belt Frame
Lock as shown.
7. Push the Top Roller in towards the toaster so the
roller slides DOWN and locks into place.
8. Push the Bottom Roller in towards the toaster so
the roller slides DOWN and locks into place.
9. Remove and discard the Top Belt (the recom-
mendation is to cut it in half so it cannot be used
again).
10. Remove and discard the Bottom Belts (the recom-
mendation is to cut them in half so they cannot be
used again).
11.
CLEAN ROLLERS: Wipe all four rollers with a
clean towel sprayed with sanitizer. Make sure to
remove all debris from the rollers so they are as
clean as possible.
NOTE: It is VERY important to clean all four rollers
whenever the belts are removed or replaced.
MAINTENANCE (continued)
Figure 5. Belt Frame Lock
Belt Frame Lock
(Closed)
Belt Frame Lock
(Open)
Lift Latch
to Unlock