A.J.Antunes HCT-5H User Manual - Hct-5H Bun Toaster
HCT-5H BUN TOASTER
5
A.J. Antunes & Co.
P/N 1011256 Rev. B 03/15
McDonald’s
Location
When placing the toaster into service, pay attention to
the following guidelines:
• Make sure power is off and the toaster is at room
temperature.
• Do NOT block or cover any openings on the unit.
• Do NOT immerse cord or plug in water.
• Keep cord away from heated surfaces.
• Do NOT allow cord to hang over edge of table or
counter.
1. Place the toaster in the required position desig-
nated by McDonald’s.
NOTE: The HCT-5H is designed to be used with the
HRT-5H toaster. When installed together, the HRT-
5H should be placed on top of the HCT-5H.
2. Attach the Bun Feeder, Crumb Tray, and Bun
Buffer Frame (Figure 1).
3. Plug the power cord into an appropriate power
outlet.
Unpacking
1. Open the large box. It contains:
• HCT-5H toaster
• Accessories box
2. Remove the accessories box from the large box.
3. With the help of another person, carefully remove
the HCT-5H from the large box.
4. Remove all protective coverings from the unit.
5. Open the Accessories Box. It contains:
• Owner’s Manual
• Bun Feeder
• Bun Buffer Frame
6. Wipe the entire exterior of the toaster and the
accessories mentioned above with a clean towel
sprayed with a McDonald’s approved sanitizer.
Allow to air dry.
NOTE: Handle accessories with care. If an accesso-
ry becomes bent or damaged, it may not attach to
the unit correctly, which may affect normal opera-
tion.
NOTE: If any parts are missing or damaged, con-
tact A.J. Antunes Technical Service IMMEDIATELY
at 1-877-392-7854 (North America only), or
630-784-1000.
INSTALLATION
Figure 1. HCT-5H Components
Bun Buffer Frame
Bun Feeder
Crumb Tray