A.J.Antunes HCT-5H User Manual - Hct-5H Bun Toaster

HCT-5H BUN TOASTER

11

A.J. Antunes & Co.

P/N 1011256 Rev. B 03/15 

McDonald’s

MAINTENANCE (continued)

INSTALLING BELTS

  1.  Follow the steps for 

Removing Belts.

  2.  Wipe both sides of the new Belts with a clean, 

sanitized towel sprayed with an approved sanitizer 

and allow to air dry.

 3. 

CLEAN ROLLERS: Wipe all four rollers with a 

clean towel sprayed with sanitizer. Make sure to 

remove all debris from the rollers so they are as 

clean as possible.

NOTE: It is VERY important to clean all four rollers 

whenever the belts are removed or replaced.

  4.  Slide the new Top Belt gently over the top rollers. 

NOTE: Make sure the belt lines up properly on the 

rollers. The snaps on the belts should face the 

inside of the top rollers. 

  5.  Slide the first crown belt over the rear top roller 

and rear bottom roller. Repeat this step for the 

club/ heel belt and the second crown belt. 

NOTE: Make sure the belt lines up properly on the 

rollers. The snaps on the belts should face the 

inside of the bottom rollers.

  6.  Return the Top and Bottom Belt Rollers to full ten-

sion:

•  Pull the Top Roller UP so it can slide out 

towards the front of the toaster into operating 

position. 

•  Push the Bottom Roller UP so it can slide out 

towards the front of the toaster into operating 

position.

  7.  Close the Belt Frame Lock firmly into place 

(Figure 5) and press the latch in Figure 5 down.

  8.  Close and latch the Side Panel.

NOTE: Inform the Store Manager after any Belt 

Replacement so new Belts can be ordered. 

  9.  Set the Compression Knob to 4.

 10.  Re-install the Bun Feeder, Crumb Tray, and Bun 

Buffer Frame. 

  11.  Plug the power cord into the appropriate outlet. 

Turn the toaster on. 

Figure 4. HCT-5H Components

Bun Buffer Frame

Bun Feeder

Crumb Tray

Fan