A-Neuvideo ANI-1201HD Instruction Manual - page 6
4
FRONT AND REAR PANEL
FRONT PANEL
q
Power indicator LED. It will display red when the unit is connected to power.
w
IR receive sensor for IR remote control.
e
Input Signal source type LED status.
r
Video signal source type selection buttons. VIDEO source type (HDMI, VGA, Component Composite and or S-Video.)
t
Signal source channel selection buttons.
y
Resolution selection buttons. 1024x768, 1280x720p, 1280x800, 1360x768, 1920x1080p.
u
MIC volume control buttons. “
MUTE” for mute MIC volume, “▲” for MIC volume up, “▼” for MIC volume down, loop controlling.
i
Line volume control buttons. “
MUTE” for mute line volume, “▲” for line volume up, “▼” for line volume down, loop controlling.
REAR PANEL
q
(2) RCA connectors for stereo audio output, one VGA output, one HDMI output with audio embedded, one HDBaseT™ for HDMI
extending (works with ANI-402R) included.
w
(4) VGA connectors for VGA inputs.
e
(4) HDMI connectors for HDMI inputs.
r
(4) 3.5mm stereo audio connectors for VGA audio inputs.
t
(1) Component video input (Y/Pb/Pr), (2) composite video inputs, (1) S-Video input, and (2) sets stereo analog audio input.
y
(1) RS-232 port for series control, (1) USB port for firmware update.
u
(2) MIC connectors: MIC with pre-amplification, LINE for audio direct input. (1) TCP/IP port for network control.
i
Amplifier with 2x 10W@8Ω output.
o
Connector for POWER.
a
Grounding connection.
A
NEU
VIDEO
q
w
e
r
t
y
u
i
q
w
e
r
t
y
u
i
o
a