A-Neuvideo ANI-PA Instruction Manual - page 4
2
FEATURES & SPECIFICATIONS
FEATURES
• (2) stereo audio inputs, switchable by push-button, RS-232 & IR remote (optional).
• Volume/Bass/Treble controllable by push-button, RS-232 & IR remote (optional).
• 2x 20Watt@4Ohm as the default amplifier output.
• Line audio output at 3.5mm jack, with volume controllable.
• Bridge connection function. User can switch the ANI-PA to be 1x 40Watt@8Ohm by bridge connection.
• Dual-mono function. User can sum up the stereo audio to two times mono audio.
• MIC mixer function. The microphone will be mixed to the line audio output, and be controlled separately.
• MIC input supports 48V phantom power, dynamic MIC and wireless MIC.
• MIC port can support balance/unbalance signal, suppress the external noise effectively.
• Noise gate function. It keeps detecting the audio and MIC input, will mute the output after 10 seconds when there is no input.
• Ultra low inrush current, no need for power sequencing. This allows multiple ANI-PA to be powered on simultaneously without
overloading power circuits.
• Convection cooled, a fan is not needed.
• Antistatic case design: providing good protection for long-term and stable performance
• LED indicator, for power and working status.
Specifications
• Audio Input: (2) Stereo audio / (1) MIC
• Input Connector: (2) RCA / (1) 3.5mm jack / (1) Captive Screw Connector
• Audio Input Impedance: >10kΩ
• Audio Output: (1) Amplifier / (1) Stereo audio
• Output Connector: (1) Captive Screw Connector / (1) 3.5mm jack
• Audio Output Impedance: 50Ω/Stereo, 4~8Ω/Amplifier
• Stereo Channel Separation: >75dB@20Hz to 20KHz
• CMRR: >70dB@20Hz~20KHz
• Frequency Response: 20Hz ~ 20KHz
• Audio IBandwidth: 20Hz ~ 25KHz
• SNR: 80dB at maximum output
• THD + Noise: 1%@1KHz, 0.3%@20KHz (at nominal level)
• Voltage Gain: 32dB
• Power Output: 2x 20 Watts (4Ohms)
• RS-232 Control: RS-232, 9-pin female D connector
• PinConfigurations: 2 = TX, 3 = RX, 5 = GND
• IR Remote: Optional IR remote (part# ANI-PAIR)
NOTE: All nominal levels are at ±10%.
As product improvements are continuous, specifications are subject to change without notice.
A
NEU
VIDEO