A-Neuvideo ANI-PA Instruction Manual - page 6
4
REAR PANEL
Microphone input
The microphone input of ANI-PA has (3) modes, and different modes use different connections, as the picture below:
1. 48V Phantom Power Input
: When the switch is set to “48V”, the MIC input will provide a 48V phantom power. This is usually used for
power supply for condenser microphone, Connection is:
“+” connects to positive, “-” connects to negative and“╧”to ground.
NOTICE: In this mode, only condenser microphone can be connected.
2. MIC Input:
When the switch is set to
“MIC”, the microphone input is used for connecting with dynamic microphone. There are (2)
different connections:
1. Unbalanced connection:
a.
“╧” connects to ground, and “-” connects to signal, or
b.
“╧”connects to ground, and “+” connects to signal.
2. Balanced connection: “+” connects to positive, “-” connects to negative and “╧”connects to ground.
3. LINE Input:
When the switch is set to
“LINE”, the microphone input is used for connecting with line level audio sources. There are (2)
different connections:
1. Unbalanced connection:
a. “╧” connects to ground, and “-” connects to signal, or
b. “╧” connects to ground, and “+” connects to signal.
2. Balanced connection: “+” connects to positive, “-” connects to negative and “╧”connects to ground.
A
NEU
VIDEO
Input modes switch.