A-Neuvideo HD-88 Instruction Manual

Manual is about: 8x8 HDMI Matrix Switcher

Summary of HD-88

  • Page 1

    Model: hd-88 8x8 hdmi matrix switcher hdmi matrix switcher series thank you for purchasing the hd-88 hdmi matrix switcher. You will fi nd this unit easy to install and highly reliable but it is essential that you read this manual thoroughly before attempting to use 8x8 hdmi matrix switcher. Part no....

  • Page 2

    Safety information 1. Save the carton and packing material even if the equipment has arrived in good condition. Should you ever need to ship the unit, use only the original factory packing. 2. Read all documentation before operating your equipment. Retain all documentation for future reference. 3. F...

  • Page 3

    Table of contents, introduction & package of contents table of contents 2 introduction and package of contents 2 features and specifications 3 edid functions 4 front panel 5 front panel - control functions 6 rear panel 7 typical application 8 remote control 9 remote control - data code list 9 ir ext...

  • Page 4

    Features & specifications features 1. Support 8x hdmi digital source devices matrix switched to 8x hdmi devices. 2. Hdmi digital video with embedded audio, dvi format and hdcp compliant 3. Seven (7) function key control and worldwide edid modes for hdtv resolutions. 4. Link speeds of up to 6.75 gbps...

  • Page 5

    Edid function edid function for hdmi matrix switcher to view the current edid status: step 1. Press edid button; the button will flash blue and the display will show the current edid status. Step 2. Press edid button to exit. To change the current edid status: method 1 step 1. Press edid button; the...

  • Page 6

    5 front panel front panel 1 power switch the power switch turns the unit on and off. The led will illuminate red to indicate that the switcher is on and is receiving power. The switcher will remember that last state during a power cycle. When power is removed and resorted, the last con fi guration w...

  • Page 7

    6 front panel front panel 9 function key - off disables (mute) video to selected channels. Either destinations. - press off button followed by any destination channel. - press 1 thru 8 output destination. The display will show ” 0 “ for the selected channel indicating no video selected. 10 function ...

  • Page 8

    7 rear panel rear panel 1 dc power inlet the switcher is fi tted with a dc power plug input connector. Ensure that the used is of an approved type and is of suf fi cient current carrying connector capacity with the correct voltage and connector polarity. 12volt~ dc power supply 3a max (center pin po...

  • Page 9

    Typical application installing diagram 8x8 hdmi matrix switcher hd-88 connection ports: control ports : 1. Ir extend - extemal ir receiver 2. Rs-232 - pc rs-232 series port inputs port signals: 1. Hdmi (hdcp compliant) 5. Hdmi (hdcp compliant) 2. Hdmi (hdcp compliant) 6. Hdmi (hdcp compliant) 3. Hdm...

  • Page 10

    Remote control before making any connections to the switcher. Observe the following: > ensure the mains voltage supply matches the label on the supplied plug-pack (+/- 10%) > ensure that the power switch is off > ensure that all system grounds (earth) are connected to a common point. > avoid powerin...

  • Page 11

    Ir extender rear panel ir extender port *** when you plug the external ir extender into the switcher, the front panel ir receiver remains active. *** ir extender package : 10

  • Page 12

    Rs-232 serial interface rs-232 serial interface connect a pc or control system. Version compatible v1.0 & v1.5 rs-232 serial interface pin rs-232 de fi nition 1 -------- not used 2 tx transmitter 3 rx receiver 4 -------- not used 5 gnd ground 6 -------- not used 7 -------- not used 8 -------- not us...

  • Page 13

    Rs-232 serial commands more stuff note: turning the unit system power 011 via rs-232 will extinguish the led channel display leaving only the power sw~ led on. The video and audio outputs will also mute. While the unit is turned 011 by rs-232 it will continue to accept and act upon switching command...

  • Page 14

    Limited warranty limited warranty the warrants this product against defects in materials and workman ship for a period of 1 year from the date of purchase. Should this product, prove defective within this warranty period, will repair this product without charge, to whatever extent it shall deem nece...