A-Neuvideo HD-88 Instruction Manual - page 13
RS-232 SERIAL COMMANDS
MORE
STUFF
Note: Turning the unit System Power 011 via RS-232 will extinguish the LED channel display leaving only the Power SW~ LED
on. The Video and Audio outputs will also mute. While the unit is turned 011 by RS-232 it will continue to accept and act
upon switching commands. For example, if the unit is in the off mode (via RS-232) and you send a command to switch
an input to an output that route will complete and the video and audio will now appear on that channel only. The front
panel LED channel display for that particular output will also show the input selected (for that single output channel
only). The remaining LED’s will remain off and video and audio outputs muted. The unit will still return status and
change messages in response to commands sent while in Power Off state. A hard reset command (SBALLRST) will
return the unit to normal operation and also unlock the front panel.
Power
Off
mode.
SBSYSMOF
- Put system into Standby (Soft Power Off)
SBSYSMON
- Bring unit out of Standby (Soft Power On)
Unit will respond with
SBALOFAK
- Unit is in Standby
SBALONAK
- Unit is no longer in Standby
Example: Put Unit in Standby (Soft Power)
SBSYSMOF
-Send
SBALOFAK
-Rcvd
FRONT PANEL LOCK
Note: Hard resetting the unit will unlock the Front Panel controls.
SBSYSMLK
- When front panel is locked, changes can only be made by RS-232
SBSYSMUK
- Front Panel Unlock
Unit will respond with
SBSYSLOK
- Front Panel has been Locked
SBSYSULK
- Front Panel has been Unlocked
Example: Lock Front Panel Buttons
SBSYSMLK
-Send
SBSYSLOK
-Rcvd
UNIT
RESET
SBALLRST
- Reset every output to Input 1
Unit will respond with
SBRSTACK
- Unit has reset each Output to Input 1
Example: Reset all outputs to Input 1
SBALLRST
-Send
SBRSTACK
-Rcvd
12