Aaeon SBC-551 Manual - page 39
Chapter 2 Installation 31
Parallel (printer) port connector
(CN4)
Normally, the parallel port is used to connect the card to a printer.
The SBC-551/552 includes an onboard parallel port, accessed
through CN4, a 26-pin flat-cable connector. You need an adapter
cable if you use a traditional DB-25 connector. The cable has a 26-
pin connector on one end and a DB-25 connector on the other.
Mounted on a retaining bracket.
Parallel port IRQ
The SBC-551/552 supports one parallel port. The port is designat-
ed as LPT1 and can be disabled or changed to LPT2 or LPT3 in the
system BIOS setup.
Pin assignments
Parallel (printer) port connector (CN4)
Pin
Signal
Pin
Signal
1
Strobe
2
Data 0
3
Data 1
4
Data 2
5
Data 3
6
Data 4
7
Data 5
8
Data 6
9
Data 7
10
-Acknowledge
11
Busy
12
Paper empty
13
+Select
14
-Auto feed
15
-Error
16
-Init printer
17
-Select input
18~25
GND