Aaeon SBC-551 Manual - page 72

64    SBC-551/552 User Manual

IDE Primary / Master / Slave PIO

This sets the hard disk PIO transfer mode, which affects the hard

disk data transfer rate.  The system will auto-detect the PIO mode

of a device in any of these positions when they are set to Auto, the

recommended setting.  Alternatively, you can set the mode

manually.  Modes 0 to 2 are supported.

Primary / Master / Slave UltraDMA

This sets the transfer mode of the UltraDMA hard disk, which

requires a drive that supports this data transfer method.  The

system will auto-detect an UltraDMA device in any of these two

positions when they are set to Auto without effect if there are no

UltraDMA devices installed.

Internal PCI/IDE

: Primary

IDE Primary Master PIO

: Auto

IDE Primary Slave PIO

:  Auto

Primary Master UltraDMA :  Auto

Primary Slave UltraDMA

:  Auto

IDE Burst Mode

:  Disabled

IDE Data Port Post Write

: Enabled

IDE HDD Block Mode

:  Enabled

Onboard FDC Controller

:  Enabled

Onboard Serial Port 1             :  3F8H

Onboard Serial Port2

:  2F8H

IR Address Select

:  Disable

IR Mode

:  HP SIR

IR IRQ Select

:  IRQ10

Onboard Parallel Port

: 378

Parallel Port Mode

:  SPP

PS/2 mouse function

:  Enabled

USB Controller

:  Enabled

USB Keyboard Support

:  Disabled

R O M   P C I / I S A   B I O S   ( 2 A 5 I I A K 9 )

I N T E G R A T E D   P E R I P H E R A L S

                                     A W A R D   S O F T W A R E ,   I N C .

Esc:Quit                   

áâàß : Select Item

F1 : Help

PU/PD/+/-: Modify

F5 : Old Values

(Shift)F2 : Color

F6 : Load BIOS Defaults

F7 : Load Setup Defaults