AAMP of America iSimple Owner's Manual - page 7
4
6. If connecting the Satellite Radio tuner (SCC1 sold separartely), make
the folllowing connections before connecting the PXAMG to the vehicle.
Plug the black end of the 3 foot PXAMGSR (8-Pin mini-din to 8-Pin mini-
din; sold seperately) into the second port (closest to the dipswitches) on
the Media Gateway. If you are installing the Satellite Radio Tuner with
the HDRT, connect the PXAMGSR cable to the port farthest from the
dipswitches. Connect the gray end of this cable into the Satellite Radio
tuner.
8. Plug the male connector on the PGHVW2 harness into the port on
the back of the radio. Next, connect the factory harness into the female
connector on the PGHVW2 harness. Be sure to make a firm connection
but do not force it.
a. If installing the Gateway into a non-navigation Touareg, then connect
the PGHVW2A adapter to the harness and media gateway.
b. All other applications, connect the PGHVW2B adapter to the vehicle
harness and to the media gateway.
Plug the black micro-fit 24-pin connector on the PGHVW2 harness into
the PXAMG Media Gateway box.
9. To complete the installation secure the Media Gateway (PXAMG) and
HD Radio tuner (HDRT) or Satellite tuner (SCC1) (Touareg only) into the
cavity behind the dash. Be sure that the cables and interface modules
are not near moving parts or sharp metal edges as they may damage
the cables. To prevent rattling noises inside the dash, use zip ties, or
electrical tape, or other fasteners to mount the interfaces to the factory
wiring or installed audio components (for example under the factory
Satellite tuner (if present).
9. With all connections made, reconnect the vehicle’s battery, insert the
key into the ignition, and turn the vehicle on. Check for proper operation
of the Media Gateway Satellite tuner and HD Radio Tuner before
reinstalling the factory dash panels.
10. When first powering up the vehicle with the radio reconnected,
“CODE” may appear on the screen. This is a safety feature of the VW
radio. If you see this message, DO NOT enter a code, simply let the
radio sit on this screen for about 10 seconds, then turn the vehicle
off. Disconnect the gateway harness from the vehicle. Reconnect the
gateway harness to the vehicle. Normal operation should resume.
11. NOTE: The first time that you access the Gateway, your radio may
display “DEV INIT” while the device is initializing. If this is displayed,
please wait one minute then cycle the ignition off and on. Access the
gateway again to begin normal operation.