AAS AAS User Manual - page 22
www.aasalarm.com
20
Change Second Entry Keypad password. Press the follow button below on Second Entry Keypad.
【
1 2 3 4
(factory password)
new password (must 4 digits)
#
】
Operation.
Arm :
【
password # 1
】
Home Arm:
【
password # 2
】
Disarm:
【
password # 3
】
Help:
【
password # 4
】
Remote Operation by Phone.
Dial your SIM card phone number
(SIM CARD is the pre-aviated and pre-paid SIM inserted into keypad/controller)
and after approximately 2 rings,
you will hear two Beeping and password sounds. That is the signal to enter the
admin
password
To arm system: press number:
“1”
This will be followed by two beeping sounds. Follow the beeps by entering the number of the function
you want to activate:
To disarm system: press number:
“2”
To two way communication: press number "3"
To monitor your home: press:
“
”,
this allows 30 seconds of listening time; press “
” for an additional 30
seconds.
To exit: press
“#”
What to do When the Alarm Auto-Dialer call you?
When you receive the recorded message from your alarm system you have three options:
Press “
”
This allows you to monitor your premises for 30 seconds. You can press “
” again for an additional
30 seconds.
Press “#”
This allows you to turn off the automatic calling system. If you do not turn off. The system will
continue dialing all of your stored phone numbers.
Handing up phone.
System will proceed to dial the next stored numbers. While the system is dialing through
the stored number you cannot call in to your phone.
Press "0" to play the pre-recorded message one more time.
While the system is dialing through the store number, you cannot call in to your
phone and disarm your system !