AAS Ascent X1 Quick Start Manual - Quick Start
2 of 4
QUICK START
GUIDE
4
Close and lock front panel.
5
Make sure gate path is clear, then
key in temporary code 2012 on
keypad and confirm gate opens.
Now follow the Activation Guide to create
an account and begin using Ascent.
INSTALLATION COMPLETE!
N
3
Connect wires
Feed wires through back of
unit and connect as shown.
STATUS POWER
EVENT
RELAY A
RELAY B
Ascent X1 Terminal Block
N/O
GND
POS. (
+)
NEG. (
–)
N/O
CO
M
N/C
N/O
CO
M
N/C
CO
M
N/O
POWER
12–24 VAC/VDC
Gate Operator / Door Opener
POS. (
+)
NEG. (
–)
CO
M
RADIO
CO
M
FREE EXIT
CO
M
REVERSE LOOP
CO
M
OPEN
ST
OP
CLOSE
12–24 VAC/VDC
Third-Party 12–24-V AC/DC
Power Source
Relay B can be wired to asecond device
in the same manner.
+ –
OR
Supplied 12-VAC
Transformer
Before proceeding,
double check that wiring is
correct and unit has power!
For additional wiring
options, see page 3.
STOP!
If you will not be using the supplied 12-VAC
transformer, please go to page 4 and follow the
procedure, Using a Third-Party Power Source.
Do not exceed 24 VAC/VDC! Failure to choose a
compatible power source can damage unit!
CAUTION!
Copyright © Security Brands, Inc.
QSG-16X1-EN Rev. D (12/2015)