AAS Ascent X1 Quick Start Manual - Quick Start
POWER
12–24 V AC/DC
Gate Operator / Door Opener
POS. (
+)
NEG. (
–)
CO
M
RADIO
CO
M
FREE EXIT
CO
M
REVERSE LOOP
CO
M
OPEN
ST
OP
CLOSE
3 of 4
QUICK START
GUIDE
A
Status Check
Wiring to enable device status check
B
Open/Close Mode
Wiring when not using gate operator’s “timer-to-close” function.
STATUS POWER
EVENT
RELAY A
RELAY B
Ascent X1 Terminal Block
N/O
GND
POS. (
+)
NEG. (
–)
N/O
CO
M
N/C
N/O
CO
M
COM
N/C
CO
M
N/O
12–24 V AC/DC
Connected as shown in Step 3
(If equipped with limit switches)
Close Limit Switch
Open Limit Switch
Optional
wire splices
N/O
N/C
COM
N/O
N/C
STATUS POWER
EVENT
RELAY A
RELAY B
Ascent X1 Terminal Block
N/O
GND
POS. (
+)
NEG. (
–)
N/O
CO
M
N/C
N/O
CO
M
N/C
CO
M
N/O
12–24 V AC/DC
Connected as
shown in Step 3
Gate Operator
IMPORTANT!
r
Open/Close Mode will only work if the device is set to that mode
from the Device Settings page in the Admin Area!
You CANNOT log in until account activation has been completed!
Copyright © Security Brands, Inc.
QSG-16X1-EN Rev. D (12/2015)