AB-COM AB IPBox 55HD User Manual - page 22

22 

Basic setting installation menu (preinstalled channel list) appears on the screen. If none 

setting is available, skip the menu otherwise choose desired one and press OK.  

Note: 

You can download Setting from the Internet or install it from your PC. 

Configuration Mode    

You can set up your antenna (outside dish) in this menu. 

There is „not configured“ setting preset in tuner configuration menu. 

Set desired configuration of tuner (tuners). 

„Simple“: 

Setting for using two LNB converters (or so called monoblock) connected DiSEqC switch ½ . 

Basic setting: 

Input 1 = A  :  Astra 19,2E. 

Input 2 = B  :  Hotbird 13E. 

Use cursor buttons to change satellites for A or B positions if your dish is aimed at different 

satellites. 

We recommend not changing the other settings. These are preset for the most common type of 

LNB - Universal. 

You can change configuration of tuners later on in the menu of the receiver. 

If your receiver is equipped with two tuners, second tuner is in the menu marked as tuner B. 

Second tuner can be also installed into your receiver additionally – type according to your 

requests: 

DVB - S2 satellite  

DVB – T terrestrial 

DVB – C cable 

The main advantages of using two tuners are wider channel list and possibility of 

simultaneous watching/recording of program from different satellites (services).  

Example of setting of DVB – T tuner: 

Configuration mode   

„enabled“ 

Terrestrial provider   

„21-69k“ 

5V active antenna 

“on” (if you use active antenna otherwise set “off”).  

Press OK to confirm. 

The question message appears on the screen: 

„Do you want to install default sat list? “ 

Select „yes“ to choose one of following four preset satellites: 

Astra2 – 28.2E, Astra1 – 19.2E, Astra 3 – 23.5E, Hot Bird - 13E 

Select “yes” for satellite that should be installed.