AB-COM AB IPBox 55HD User Manual - page 63
63
Conclusion
AB IPBox team consecutively improves and develops firmware for AB IPBox receivers.
We try to create new useful functions and expand capability of the IPBox receivers.
Thanks to open architecture of used operating system Linux, also anonymous users can
participate on the development.
Latest software and information can be found on our technical support web page
(
http://download.abcom.sk/
) or on other independent servers and forums.
Installation of a new firmware:
Enigma2 firmware for AB IPBox 99xx receivers contains following two files:
usb_rootfs.img
usb_kernel.img
There is a difference between firmware for AB IPBox 55HD, AB IPBox 99HD and
9900HD! They cannot be exchanged!
Make sure, that you are going to install a correct firmware into your IPBox.
1. Copy both files (do not change the names) from your PC into main (root) folder of
your USB flash disk (FAT32 or linux ext3. format).
2. Connect the USB disk with the files to USB connector on front or rear panel of your
receiver.
3. Turn off the power by using power switch on the rear panel of the receiver.
4. Wait approximately 3 secs and turn on the power back. Watch the display. When
message „loader…“appears on the display, immediately press and hold
„Standby“ button on front panel. Hold until “USB UPGREADE” message is
displayed. Release the button.
5. Installation process begins. Whole process lasts approximately 15 mins.
Do not turn off the receiver or disconnect the USB flash disk during installation!
Wait until the end of all installation!
The end of the installation is indicated by „Update complete“ message on LCD
display.
6. The IPBox will automatically restart newly installed image.
7. Wait until „Initial Setup Wizard“ menu is displayed. Follow the instructions at the
beginning of this manual.
We wish you good luck and plenty of great experiences with your AB IPBox receiver.
Your ABCOM team.