Ab Platinum Series User Manual - page 16
28 User Guide for the Platinum Series Sound Processor
User Guide for the Platinum Series Sound Processor 29
Headpiece
To Replace the Headpiece:
• Turntheprogramcontroltotheoff(o)position.
• Removetheheadpiecefromthecablebyholdingthecableatitsstrainrelief
portion and gently pulling the cable away from the headpiece .
• Insertthecableintothereplacementheadpiece.
• Repeatthesystemcheck,steps1-3.
NOTE: Be sure the processor is turned off before removing the headpiece cable.
When replacing the processor headpiece we recommend that you consult with your
programming center to verify proper headpiece fitting and sound quality adjustment .
engages into place on the processor . Do not force the battery . It is designed to
be inserted in only one direction; forcing may jam or damage the slide mechanism .
• Performthesystemchecksequence,Steps1-3,asdescribedatthebeginningof
this section .
To Replace the AA Battery Compartment:
• UnsnaptheAAbatterycompartmentutilizingthethumbrecessonthetopof
the compartment .
• InsertAAbatteriesintothebatterycompartment,makingsurethatthepositive
and negative contacts are in the correct orientations, as labeled inside the cover .
• Replacethecoverbyhookingthecasetogetheratthebottomandgently
snapping it closed .
• Aligntheslidetrackonthetopofthereplacementbatterycompartmentwith
the slide track on the underside of the processor .
• Guidethebatterycompartmentontotheprocessorslidetrackandslideuntilit
engages into place on the processor . Do not force the battery compartment, it
is designed to be inserted in only one direction . Forcing the battery compartment
may jam or damage the slide mechanism .
• Performthesystemchecksequence,steps1-3,asdescribedinthebeginningof
this section .
The Cable
The cable transfers signals between the headpiece and the processor . At one end of
the cable is a right-angle single-pin (coaxial) plug that is inserted into the headpiece
jack . The jack is located at the top of the processor . At the other end of the cable is
a straight single-pin (coaxial) plug that is inserted into the headpiece . A strain relief
portion near the plug is designed to protect the cable from damage during handling .
To Replace the Cable:
• Turntheprogramcontroltotheoff(o)position.
• Removetheheadpiecefromthecablebyholdingthecableatitsstrainrelief
portion and gently pulling the cable away from the headpiece . Disconnect the
cable from the processor .
• Inserttheright-angleplugofthereplacementcableintotheheadpiecejackon
the processor, and insert the straight plug into the headpiece connector .
• Repeatthesystemcheck,steps1-3.Ifthemicrophonefunctionisnotrestored,
reconnect the first cable, and replace the headpiece .