ABB A130-H57 Operation Manual - 3.2

Operation Manual / 4 Product description / A130-H.. - A140-H

3  Commissioning / 3.2  Inspection procedures

© Copyright 2017 ABB. All rights reserved.

HZTL4030_EN

Revision D

May 2017

3.2

Inspection procedures

3.2.1

Introduction

Inspection procedures include preventative visual controls, monitoring and measuring work

before and during commissioning. Inspection procedures enable changes to the turbochar-

ger to be detected. Engine damage can be prevented.

3.2.2

Checks before commissioning

Filter mat (if available)

u

Check for damage and contamination.

Lubricating system

 CAUTION

Contaminated oil

Serious damage to engine or property can be caused by dirt and solid ma-

terial particles in the oil.

u

For the initial commissioning phase and after all service work, flush the

complete lubricating system with warm oil.

u

Use special running-in filters when running in the engine and after all ser-

vice work on the lubricating system.

u

Check that the oil filter is clean before commissioning.

u

Check the oil pressure in the oil supply pipes.

Warning plates

u

Check whether warning plates are present and legible.

u

Check whether the protective sheets have been removed.

Version with compressor wheel cooling:

 CAUTION

Failure of compressor wheel cooling

Any prolonged failure of the compressor wheel cooling will shorten the re-

placement interval of the compressor wheel.

u

Make sure there is an uninterrupted supply of cooling air during opera-

tion.

u

Check whether the compressor wheel cooling is fitted on the bearing casing.

Page 

22

 / 

91