ABB PSTX210 Service Manual - page 69
1SFC13105M0201 | Service Manual |
Service PSTX470...570
69
5.
Place side- and front covers
Make sure to position side covers with dual locking
rails facing upwards prior to assembly.
1
Interlock the side covers to rails and attach
them to support brackets mounted on cooling
towers.
2
Place the front cover on the unit and interlock
to rails.
3
Thread the cables through the cable inlets
opening in the front cover.
6.
Place fan cover
1
Thread the fan cables through the cable inlets.
2
Fasten fan cover to the unit with
(6x)
Torx
20
M4x8 (2,9Nm).
Screws are to be mounted in
each corner, and on the center bracket, of the fan
cover.
7.
Place top cover
1
Fasten top cover to the unit with
(6x)
Torx
20 M4x8 (2,9Nm)
. Screws are to be mounted in
each corner, and on the center bracket, of the top
cover.
REASSEMBLE THE SOFTSTARTER
Place PCBA, cables and front cover
Place the PCBA, connect all cables and install the
front cover as described in
chapter 4.4.1, step
6-10
.
Connect main power cables and control
cables
Connect the main power cables and the control
cables as described in
chapter
4.3.4,
step 1-2
.
5
4.5.4_5
1
2
3
Tx 20
M4 x 8
(2,9 Nm)
6
4.5.4_6
1
2
Tx 20
M4 x 8
(2,9Nm)
7
4.5.4_7
1
4