Ability Research AbilitySpeaker User Manual And Instructions - page 3
NOTE
Be Sure to read and save this intruction booklet.
Connecting the AbilitySpeaker to the ActionVoice-2A
****** IMPORTANT *****
NOTEThe AbilitySpeaker MUST BE USED WITH an ActionVoice-2A (Model number
ACTV-2A). The label on the bottom of the ActionVoice shows the model number. If
you have any other model or if you are not sure, contact Ability Research for more
information or about having your unit upgraded to that model.
Connect the AbilitySpeaker to the ActionVoice-2A as described below and shown in
Figure 1.
1.Connect the plug labeled “Connect to Speaker/Phones” to the Speaker/Phones
jack on the ActionVoice.
2.Connect the plug labeled “To Switch Closure Output 2” to the Switch Closure
Output 2 jack on the ActionVoice.
3.
Plug the pillow speaker into the AbilitySpeaker.
NOTEHandle the connectors and not the cords when connecting or disconneting. Never
pull on the cords or use them as handles.
2
Ability Speaker Instructions