Ability Research AbilitySpeaker User Manual And Instructions - page 7
STEP 2: Set Option 2. Make sure Scanning and Auditory Mode are also set. (When
Auditory Mode is set, messages and prompts will play through BOTH the pillow
speaker and the AbilitySpeaker, while ONLY messages will play through the
AbilitySpeaker.)
STEP 3: To get out of setup mode, press the “Record/Setup” key again. The
AbilitySpeaker system is now ready for use.
Refer to the ActionVoice manual for more details on programming and setup
mode.
Operation of the AbilitySpeaker
Once the ActionVoice is set up, recorded with messages and prompts and the
AbilitySpeaker and pillow speaker are connected, the system is ready for use.
Message and prompt loudness are adjusted by the volume control on the bottom of the
ActionVoice. This is the primary way to control the public (message) volume level.
Prompt loudness is then separately set using the volume control built into the pillow
speaker.
HINTIt is best to set the ActionVoice (Message) volume control first. This sets the
maximum loudess for prompts. Then use the pillow speaker volume control to reduce
level as necessary for comfort of the user.
TIPThe pillow speaker maximum volume level is less than the AbilitySpeaker. It is
6
Ability Speaker Instructions