ABRIVO X-EO Quick Reference Manual - page 3
HOLD/DND (Hold/Do Not Disturb) - This key is used to put a call on Hold or to set the Do
Not Disturb function to prevent any calls from getting through or ringing at your extension.
Handset Volume Control - The handset volume control key allows you to adjust the hand-
set volume to one of three levels. Pressing the button will toggle between the three volume
levels.
Speaker Volume Control - The speaker volume control key allows you to adjust the vol-
ume control of the speaker when using speakerphone. Pressing the [+] key raises the vol-
ume to one of nine settings. Pressing the [-] will decrease the volume.
Ringer Volume Control - Pressing the ringer volume control button allows you to adjust the
ringer volume to one of four levels.
[Mute] Key - When talking using the handset, pressing the [Mute] key mutes the handset
transmitter. If using the speakerphone, pressing the [Mute] key mutes the station micro-
phone. When using the headset jack, the [Mute] key mutes the transmitter on the headset.
ICM - The intercom system is the internal network used to communicate between the tele-
phone extensions in your
X-EO system. Pressing the [ICM] key connects you to an intercom line for conversation with
other extensions.
Making an Outgoing Call
♦
Lift the receiver
♦
Press an outside line button. You will hear a dial tone.
♦
Dial telephone number
Make a dialing mistake?
♦
Press the [FLASH] button to get new dial tone
♦
Dial again
Receiving an Incoming Call
♦
When your phone rings and lamp flashes
♦
Lift the receiver to connect the call
If your phone does not connect you to the call automatically
When your phone rings and lamp flashes
♦
Lift the receiver
♦
Press the button with the flashing lamp to
connect the call