ABS 100 Installation And Operating Instructions Manual - page 7
7
ABS lifting station Piranhamat
ABS lifting station Piranhamat
4
S f h P h m 100/10
ATTENTION
A maximum of a one toilet, one wash-hand basin, one bidet and a single shower tray
may be simultaneously connected to the Piranhamat 100/120 unit. The WC must be
directly connected without the use of an intermediate pipeline to the Piranhamat
100/120 unit.
m
The inflow lines from the wash-hand basin and the shower tray must have an inflow height such that
the lowest part of the inflow line has an inflow height of at least 180 mm. This is to ensure that the
inflow lines can discharge fully by gravity, and that back-up cannot occur.
ATTENTION
see note under 1.2.1 (* version with part no.07500320/07565092)
4.1
Installation - inflow side
ATTENTION
When installing the discharge line ensure that Section 5.1.1 Discharge line is
observed.
The Piranhamat 100/120 (1) is designed for a direct toilet connection. The Piranhamat 100/120 unit is set-up
directly behind the toilet. The sealing sleeve should be drawn up directly on to the toilet outlet pipe DN 100 (3).
In order to comply with DIN standards the inflow lines from the wash-hand basin bidet and shower tray must
be at least 180 mm above the container base and provision for inflow by gravity must exist in order that these
inflow lines will remain clear.
1 Piranhamat 100/120
1108-00
2
Connection for a wash-hand
basin, bidet or shower.
3
Sealing sleeve for direct
toilet connection.
Figure 5 Inflows to the Piranhamat 100/120